Electrolux EOG2100 User Manual page 20

20 www.electrolux.com
13.4 Building-in the appliance
Conditions for building-in:
• Only set up the appliance in a kitchen
or in a kitchen-dining room.
• Do not set up the appliance in a bath-
room or a bedroom.
• You can install the appliance "built-in"
or "built-under":
570
110mm
580mm
65cm²
x2
www.markabolt.hu
540
560
2
594
min.
550mm
560-570mm
130cm²
110mm
593mm
20
65cm²
x2
• The related illustrations show the nec-
590
essary dimensions of the oven and the
cabinet (in millimetres).
• The dimensions of the built-in cabinet
must agree with the related illustrations.
• There must be a minimum clearance of
4 mm between the top surface of the
appliance and the inner top of the cabi-
net.
• When you install the appliance "built-
under" (below a hob), install the hob
before the oven unit.
• The materials must be resistant to a
temperature increase of minimum 60
°C above the ambient temperature.
• There must be a continuous air supply
around the oven in order to not have
the oven become too hot.
• For correct operation, the oven cabinet
must have a minimum opening of 130
cm² in the front or on the sides (a mini-
mum of 65 cm² for each side). The
manufacturer recommends a 130 cm²
opening in the front for a brick cabinet
and a 65 cm² opening for each side for
a wooden cabinet.
• When you install a hob above the oven,
make different electrical connections for
the hob and for the oven.
Only make connections with correct ca-
bles for the power supplied.
Make sure that after the installa-
tion, an engineer can have easy
access to the oven if repairs or
maintenance are necessary.
min. 4mm
min.
550mm
560-570mm
130cm²