Electrolux EOG2100 User Manual page 19

D
E
WARNING!
A primary air adjustment of the
gas oven burner is not necessary.
Minimum level adjustment of the gas
oven burner:
1.
Disconnect the mains plug from the
mains socket.
2. Turn the control knob to the minimum
position and remove it.
3. Adjust the adjustment screw (G) with
a thin bladed screwdriver.
Change of
type of gas
from natural
gas to liquid
gas
www.markabolt.hu
3.
F
4.
5.
6.
G
Adjustment of
the adjust-
ment screw
fully tighten the
adjustment
screw
Carefully move the gas oven burner
off the injector support (D).
Slowly move it to the left side. Make
sure that the gas oven burner bush
stays on the burner mouthpiece. Do
not apply force to the wire of the
spark plug connector (E) and to the
thermocouple conductor (F).
Unscrew the gas burner injector (D)
with a 7 mm socket spanner and re-
move it. Replace it with the necessa-
ry one (see the table "Gas Oven
Burner Data").
Assemble the gas oven burner in the
opposite sequence.
Replace the gas type sticker near the
gas supply ramp with the one appli-
cable to the new gas type (supplied
with the injector kit).
Change of
type of gas
from liquid gas
to natural gas
4.
Attach the gas oven control knob.
5. Put the mains plug into the mains
socket.
WARNING!
Only put the mains plug into the
mains socket after you put back
all the parts into their initial posi-
tions.
6. Light the gas oven burner (see "Gas
oven cooking - Ignition of oven gas
burner").
7. Set the gas oven control knob to 240
and let the oven heat for 10 minutes
minimum.
8. Turn the gas oven control knob from
240 to minimum.
Control the flame. If the flame goes out,
do the procedure from point 1 to point 7
again. There must be a small regular
flame on the gas oven burner crown.
The manufacturer is not responsible if
you do not follow these safety meas-
ures.
ENGLISH 19
Adjustment of
the adjust-
ment screw
release the ad-
justment screw
approximately
3/4 of a turn