Beko B7S-B7SLED Service Handbook page 43

If the product does not have an emergency water drain hose, in order to drain the water:
a. In order to collect the water to flow out of the filter, place a large vessel in front of the
filter.
b. Turn and loosen the pump filter until water starts to flow (counterclockwise). Fill the
flowing water into the vessel which you put in front of the filter. Always keep a piece of
cloth handy to absorb any spilled water.
c When the water in the machine ceases, turn the pump filter and remove it fully.
4. Clean the residues inside the filter as well as the lint, if any, around the propeller.
5. Replace the filter.
WARNING: If the product has water jet feature, place the filter in its housing inside
the pump. Never force the filter while installing it into its housing. Seat the filter into
its place completely. Otherwise, water may leak out from the filter cover.
6. Close the filter cover by pressing on where the tab is located if the cover is two-piece. If it
is one piece, seat the tabs in the lower part into their places first, and then press the
upper part to close
B7S B7SLED WASHING MACHINE SERVICE HAND BOOK
Figure 7.7 Cleaning the filter - 4
43