Starting The Selected Programs - Beko B7S-B7SLED Service Handbook

(until you see "E00" on 7Segment display, and until all Time Delay LEDs are off in the
LED model).

6.10. Starting the selected programs

If the Time Delay duration has been reset by switching to "Pause" mode:
-Press the "Start/Standby" button. Selected program will be started.
If the Time Delay duration has been reset without switching to "Pause" mode:

If the Time Delay button is not pressed on for 3 seconds after the Time Delay duration is
set, selected program will be started automatically (It is not necessary to press the
"Start/Standby" button).

After the program is started by cancelling the time delay with one of these two methods,
"Ready" LED will turn off and the tracking LED corresponding to the first step of the
started program will turn on (7Segment display will show the total duration of the selected
program, if any)
Starting the Program
 Program is started by pressing the Start/Standby button.
 Door is locked electronically and therefore "Ready" Tracking LED is turned off. The
program tracking indicator LED corresponding to the first step of the program
started is turned on.
Progress of the Program

Progress of an ongoing program is shown by the program tracking indicator LEDs.
At the beginning of each program step, indicator LED corresponding to the first step is
turned on. For example if "Rinse" program is started, "Rinse" tracking LED is turned on
and others are turned off. When each phase of wash is finished, the corresponding LED
is turned off and LED of the next wash phase is turned on. For example, if the Cotton
program is started, first (after the door is locked), "wash" LED is turned on, other tracking
LEDs are turned off). After the washing phase is finished, "Wash" LED is turned off and
the "Rinse" LED is turned on until the last spinning phase. After the softener step is
finished and last spinning phase is applied, "Rinse" LED is turned off and "Spinning" LED
is turned on. After the last Spinning step is finished, "Spinning" LED is turned off and the
the "End" LED which indicates that the operated program has finished is turned on.
7Segment display, if any, shows "End".
After the program is finished in this way, if the conditions to open the door are met (if the
water level is appropriate, etc.), door is unlocked electronically and the door lock is left to
1-2-minute cooling phase. "Ready" tracking LED flashes in this 1-2-minute duration.
When the door lock contact is opened mechanically (when the door lock is disengaged),
"Ready" LED turns on solid and the machine switches to "Standby" (energy saving)
mode. All LEDs on the machine apart from "Ready" and "End" tracking LEDs are turned
off. (7Segment, if any, is also turned off). "Stand By" mode is maintained for 3 minutes.
Microprocessor is "RESET" at the end of the 3 minutes. After microprocessor is "RESET",
those LEDs corresponding the Temperature, Speed and Auxiliary Function of the finished
program will be turned on for 1 minute (7Segment, if any, "End" is displayed again). Entry
into and exit from the "Stand By" mode is maintained in this way.
B7S B7SLED WASHING MACHINE SERVICE HAND BOOK
33