Beko B7S-B7SLED Service Handbook page 31

Crease Reduction
•
If the Crease Reduction Auxiliary Function is selected, intermediate spinning steps are
bypassed, last spinning step is performed at a low speed with a special spinning profile.
This function provides crease reduction and makes it easy to iron the items.
Soaking:
•
If the Soaking Auxiliary Function is selected, the laundry is soaked in water in the
softener step (in the last rinse water) and the spinning function is suspended. For the
spinning process, spinning speed should be preferred and "Start/Standby" button should
be pressed. (If the spinning speed is not selected, only pumping is performed without
spinning and the program is ended.)
•
This function is applied for the laundry to crease less since the laundry will not be taken
out of the machine immediately at the end of the program.
In addition to this, this function can be preferred for the laundry to smell softener more.
Soaking:
•
If the Soaking Auxiliary Function is selected, laundry is washed with a medium level
mechanical movement at the beginning of the wash for the laundry to be soaked,
detergent to be solved and permeate through the laundry, and is heated at a low
temperature. Then the laundry is washed with a very slow mechanical movement for a
long time. Next washing step is carried on without draining.
•
This function is used for pre-operation before wash, which ensures that the tenacious and
old stains on the laundry are softened.
Time display
•
When a program is running, remaining time for the program to be completed is displayed.
Time is shown as "1:45" in hours and minutes. ":" is flashed once in a second and this
emphasizes that the machine is operating.
Length of a program depends on the program type and selected auxiliary
functions. Details given in the "Technical data and consumption figures" table are for
the programs which do not have auxiliary functions.
Time Delay (in all of the 7Segment models and in some of the LED models)
•
You can delay the starting time of the program with the Time Delay function.
 7Segment model:
Time Delay can be applied up to "19" hours. Time delay can be set in increments of 1
hour
(1,2,3, .. 19). When the Time Delay is set, 3 horizontal lines are shown in the far left
segment (step) of the 7S display and to the right of this the set hour is shown. When the
Time Delay is started (when "Start/Standby" button is pressed), to show that the time
delay is counting down, 3 horizontal lines at the far left are flashed in turn (the animation
that the Time Delay is emphasized).
B7S B7SLED WASHING MACHINE SERVICE HAND BOOK
31