Beko B7S-B7SLED Service Handbook page 38

Adding More Laundry
This is possible only in the following situations:
During a Time Delay
At the beginning of a wash (machine may let you add laundry at a later step only if the water
level in the machine is low or the temperature is low).
 Press the Start/Standby button. If the door opening conditions are met, "READY" LED
starts to flash. It goes on for 1-2 minutes. When the "READY" LED keeps on solid, the
door can be opened mechanically. Open the loading door after this moment and add
more laundry.
 Close the loading door.
 Press the Start/Standby button.
Program in Soaking Position

If this feature is selected for any program, program proceeds until completion of the
Softener step. Then it waits without draining the water. Meanwhile, since the program is
switched to "Standby" position in the "Spinning" step, "SPINNING" program tracking LED
is flashed. In addition to this, 7Segment display, if any, shows the bucket symbol "\_/".
If you want to perform intermediate spinning:
 Set the spinning speed.
 Press the Start/Standby button. Program continues, drains the water and spins.
If you want to drain the water without spinning:
• Press the "Start/Standby" button without pressing the speed setting button. Program
continues and completes the program by only draining the water.
Re-spinning the Laundry

Automatic spinning-correction-system may prevent spinning in case the drum loses its
balance. If you want to spin the laundry again:
Re-arrange the laundry which is previously available in the drum;
Set the spinning program;
Set the spinning speed.
Restart the spinning program by pressing the "Start/Standby" button.
After the Program Ends

When the program ends, "END" tracking LED keeps on solid. 7Segment display, if any,
shows the "End". If the door opening conditions are met when the program ends,
"READY" program tracking LED is turned on and off. When the door is opened
mechanically, "READY" LED is kept on solid. From this moment,
Open the loading door and remove the laundry;
Turn the Program Selection Switch to "On/Off" position;
Shut the water tap;
Eliminate the bending in the rubber seal and check for any foreign particles;
Keep the loading door and the detergent dispenser open to dry.
Waters coming from the prewash and main wash inlets at the same time are made to crash
into each other and directed to softener compartment. There is not any separate valve outlet
for the softener compartment. Machine keeps on washing process after the softener is taken.
B7S B7SLED WASHING MACHINE SERVICE HAND BOOK
38