Product Installation / Installation Rules / Settings; Correct Place For Installation; Removing The Package Support - Beko B7S-B7SLED Service Handbook

5. Product Installation / Installation Rules / Settings

Apply to the nearest Authorized Service agent for the installation of your product. In order to
make your machine ready for use, before calling the authorized service, make sure that
electrical installation, clean water installation and water drain are appropriate by checking the
user manual. If this is not the case, call for a qualified electrician and technician and take
necessary actions.
Customer is liable to prepare the place of installation for the product, electricity, clean water
and waste water installations.
Installation and electrical connections of the product should be performed by Authorized
Service. Manufacturer cannot be held responsible for any damages which might arise due to
the operations performed by unauthorized persons.
WARNING: Before use, check whether there is any damage on the product. If the product is
damaged, do not have it installed. Damaged products pose a risk for your safety.
Make sure that the water inlet and drain hoses and the power cord of the machine are not
folded, pinched or broken during when the product is pushed into its place after the installation
or cleaning works.

5.1. Correct Place for Installation


Place the product flat and level on a hard floor. Do not put it onto a carpet with high pile
or other similar surfaces.

The product should not be placed on the border or broken ground.

When the washing machine and drier are placed on top of each other, their total weight –
when loaded– amounts to 180 kilograms. Place the product onto a sound and flat surface
having an adequate load bearing capacity!

Do not place the product on the power cable.

Do not install the product in the environments where the temperature falls below 0 ºC.

Leave a minimum space of 1 cm between the machine and the furniture.

5.2. Removing the Package Support

Figure 5.1
B7S B7SLED WASHING MACHINE SERVICE HAND BOOK
10
Tilt the machine backwards in order to
remove the package support. Remove the
packaging reinforcement by pulling the
ribbon.