Quick Instructions For Daily Use - Beko B7S-B7SLED Service Handbook

6.11. Quick Instructions for Daily Use

Preparation

Open the water tap fully. Check whether the pipes are tightened securely or not.
check that the drain pipe is hooked to the drain properly.

Load the laundry into the machine.

Add detergent and softener.
Starting

Turn the Program Selection Switch to the desired position

(Except the "On/Off" position. Energy of the machine is cut at the "On/Off" position);

Select the temperature (for the models having Temperature Selection Button);

Set the spinning speed;

Select the desired Auxiliary Function;

Set the Time Delay if required;

Close the loading door;

Press the Start/Standby button.
 In the models having the segment screen:

If Time Delay is set, Time Delay amount is shown in hours and animation starts to show
the Time Delay countdown (3 horizontal lines at the far left of the 7Segment are flashed
in turn). After elapsing of some time equal to the set Time Delay, display shows "E00"
and selected program is started automatically. After this moment, total time which is
required for the completion of the program is shown on the screen ("h:mm" h: hours, m:
minutes). ":" flashes once in a second in order to indicate that the program is in progress.
If the Time Delay is not set, selected program is started and total time which is required
for the completion of the program is shown on the screen ("h:mm" h: hours, m: minutes).
":" flashes once in a second in order to indicate that the program is in progress.

Check from the program tracking LEDs that the "READY" LED is turned off. If it is not
turned off, it means that there is a problem with the door circuit or mechanics. Open and
close the door again. From the other program tracking LEDs, program tracking LED
corresponding to the first step of the started program is turned on and others are turned
off.
Cancellation of Program

To cancel the program in progress, the only method is to change the position of the
Program Selection Switch. When the program is cancelled in this way, the water inside
the washing machine is not drained. If the water is wanted to be drained,
"Pump/Spinning" program should be selected, Speed level should be set to zero and
"Start/Standby" button should be pressed.
Starting a New Program after Program Cancellation

If the program in progress is cancelled with the position of the program selection switch
being changed, water will not be drained as described above. If the program is started in
the new position in this way ("by pressing the Start/Standby" button), likewise the water
inside the washing machine is not drained. If this water is adequate for the newly started
program, it is resumed. If it is not adequate, water is taken by opening the valve and the
washing started after the water level is completed.
B7S B7SLED WASHING MACHINE SERVICE HAND BOOK
37
Also