Beko B7S-B7SLED Service Handbook page 35

Changing the Settings of an Ongoing Program:
Changing the Program Settings by Switching the Machine into the Standby Mode:

When a program is in progress in the washing machine, the machine is switched to
pause mode by pressing the "Start/Standby" button briefly. In order to show that the
machine is switched to pause, program tracking LED corresponding to the washing step
when the machine is switched to pause mode is flashed. For example, if it is switched to
"PAUSE" at the WASHING step, "WASH" LED flashes. If it is taken into the "PAUSE" in
the last spin step, "SPIN" LED flashes. When the WM is in pause mode, auxiliary
functions appropriate to the current step of the machine can be cancelled and selected,
spinning speed can be changed (if it is not at the spinning step), temperature level can be
changed in the models having temperature button (if it is not switched into the "Pause"
mode in the heating step). Door can be opened in the water level is appropriate;
"READY" warning LED flashes until the door lock opens. When the "READY" LED starts
to light solid, the door can be opened. If the front door cannot be opened due to security
reasons, "READY" LED remains off. If the door lock "READY" LED flashes, it means
that the door is not opened yet due to safety reasons. Door can be opened when the
"READY" LED starts lighting solid. New laundry can be put into the machine from this
time on. To change the program settings, it is not possible to add extra laundry in the
second method described below.
Without pressing the Start/Standby button when a program is in progress (without
switching to Pause Mode):
Changing the Program Settings:

When the washing machine is in progress, without switching the machine to "Standby"
position, the temperature, speed and auxiliary function settings of the then current
program (appropriate to the then current program) can be changed. The single condition
for this is that the desired change should not concern the steps which are already in
progress then.

For example, if the spinning speed is wanted to be changed, no spinning should be in
progress.
Child Lock

You can prevent the children to tamper with the machine with the child lock. No change
can be effected in an ongoing program when the child lock is engaged.

Child lock is engaged by pressing the 2nd auxiliary function buttons for 3 seconds. 7S
display, if any, shows this 3-second time as "C03, C02 and C01" and the
(child lock is active) is displayed at the end of the 3rd second. If any button is pressed
when the machine is in child lock or the Program Selection Switch is turned on, the same
sentence is shown. In addition to this warning, LEDs of the 1st and 2nd auxiliary function
buttons are turned on and off for 3 times. When any program is operating, if the program
selection switch is turned to "On/Off" position and another program is selected
afterwards, program which was operating previously resumes from where it was
interrupted. To alert the user that the Child Lock is engaged, LEDs of the 1st and 2nd
auxiliary function buttons are flashed for 3 times. Also, the 7Segment display, if any,
displays "Con" for 3 seconds.
B7S B7SLED WASHING MACHINE SERVICE HAND BOOK
35