Perform Setting Of Feeding And Take Up - MIMAKI JV33-260BS Operation Manual

Perform setting of feeding and take up

For the setting of feeding and take up, there are "Setting of UNIT SELECT" which is used to set whether the
heavy medium take-up device/the heavy medium feeding device is used or not and " which is used to set the
operating position of the tension bar for the heavy medium feeding device.
Setting of UNIT SELECT
This is used to set whether the heavy duty take-up device/the heavy-duty feeding device is used or not.
• For setting of UNIT SELECT, when you set "OFF" to the heavy duty take-up device/the heavy -duty
feeding device, be sure to fix tension bars of each device at the lock position before performing setting.
Especially, if the tension bar for the take-up device is not locked, the take up setting cannot be switched
to "OFF".
1
Press the
2
Select [MACHINE SETUP] by pressing the
3
Press the
4
Select [Feeding / TakeUP] by pressing the
5
Press the
6
Press the
7
Press the
Item selecting : by the
Unit setting
8
Press the
• If you perform setting of the tension bar continuously, operate the procedures from Step 6 of "Setting of
Tension Bar Position".
9
Press the
3-28
key in the local mode.
key.
key.
key.
keys to change the setting.
keys
: by the keys
key.
key several times to end.
F UNC T I ON
S E TUP
keys.
F UNC T I ON
MACH I NE SE T UP
MACH I NE SE T UP
DEODOR I Z E F AN
keys.
MACH I NE SE T UP
F e e d i n g / T a k e UP < e n t >
F e e d i n g / T a k e UP
UN I T SE L EC T
F EED I NG : T A KE - UP
ON
< EN T >
< EN T >
< e n t >
< e n t >
ON