Table of Contents
Advertisement
When not using for a long term (CUSTODY WASH) (firmware Ver.3.20 or older)
When the operation of the machine is to be suspended for a week or more, use the [CUSTODY WASH] function
to clean the nozzles in the heads and the ink discharge passage.
After the cleaning, store the machine properly.
This function is available for the firmware Ver. 3.20 or earlier.
Check the followings
in advance.
• When the following messages are indicated, check the waste ink tank, and then operate it, referring to
P.5-38 "If Waste ink tank confirming message is displayed" according to the situation.
1
Press the
2
Select [CUSTODY WASH] by pressing the
3
Press the
• The carriage moves onto the platen.
4
Clean the wiper and the bracket.
(1) Open the front cover then pull out it by holding projections at both ends of the wiper.
(2) Clean the wiper and bracket with a clean stick dipped in cleaning solution for maintenance.
(SPC-0563)
(3) Insert it in the original position by holding the projections at both ends of the wiper.
5
Press the
5-14
Is [NEAR END] or [NEAR END] displayed ?
• The cleaning solution or ink is absorbed in washing.
At this time, washing is unable to operate if the ink end or near-end is detected.
• Replace it with a cartridge undetected for the ink end or the like.
C o n f i r m a w a s t e t a n k
C o n t i n u e <
> E x c h a n g e
key in the local mode.
key.
key.
C o n f i r m a w a s t e t a n k
E x c h a n g e
:
e
S T . MA I N T ENANCE
CARR I AGE OU T
keys.
S T . MA I N T ENANCE
CUS TODY WA SH
WI PER C L EAN I NG
COMP L E T ED ( NEX T )
F i l l
t h e
COMP L E T ED ( NEX T )
n t
< e n t >
< e n t >
: e n t
Projection
l i q u i d
: e n t
Advertisement
Table of Contents
