Perform setting of feeding and take up
For setting of feeding and take up, there are "Setting of UNIT SELECT" to set whether to use the heavy media
take-up unit/feeding unit or not and "Setting of Tension Bar Position" to set the tension bar operation position for
the heavy media feeding unit.
Setting of UNIT SELECT
This is used to set whether the heavy duty take-up device/the heavy-duty feeding device is used or not.
• For setting of UNIT SELECT, when you set "OFF" to the heavy duty take-up device/the heavy -duty
feeding device, be sure to fix tension bars of each device at the lock position before performing
setting. Especially, if the tension bar for the take-up device is not locked, the take up setting cannot be
switched to "OFF".
1
Press the
2
Press
3
Press the
4
Press
5
Press the
6
Press the
7
Press
Item selecting : by the
Unit setting
8
Press the
• If you perform setting of the tension bar continuously, operate the
procedures from Step 6 of "Setting of Tension Bar Position".
9
Press the
3-30
key in LOCAL.
to select [MACHINE SETUP].
key.
to select [Feeding/TakeUP].
key.
key.
to change the setting.
keys
: by the
keys
key.
key several times to end the setting.
F UNC T I ON
S E TUP
< EN T >
F UNC T I ON
MACH I NE SE T UP
< EN T >
MACH I NE SE T UP
DRY F AN
< e n t >
MACH I NE SE T UP
F e e d i n g / T a k e UP < e n t >
F e e d i n g / T a k e UP
UN I T SE L EC T
< e n t >
F EED I NG
:
T A KE - UP
ON
ON
F e e d i n g / T a k e UP
UN I T SE L EC T
< e n t >