Body Solid GDCC250.1 Owner's Manual page 18

S T E P
6
Be careful to assemble all components
in the sequence they are presented.
Finger tighten all hardware in this step unless otherwise noted.
A. Insert Upright Frame (F) into Base Frame (A) and secure using:
Two 8 (M8x15 hex head bolt)
Two 9 (M8x20 hex head bolt)
Two 20 (M8 arc washer)
Two 21 (M8 washer)
NOTE: Pay special attention to the orientation of Upright Frame (F) as shown in the
B. Insert three End Caps (33) into Top Frame (B) as shown.
C. Connect Pulley #3 (25) to Top Frame (B) using:
One 5 (M10x45 hex head bolt)
Two 19 (M10 washer)
One 13 (M10 nylon nut)
D. Connect Pulley #6 (25) to Top Frame (B) and secure using:
One 6 (M10x85 hex head bolt)
One 37 (steel bushing)
One 29 (steel bushing)
One 13 (M10 nylon nut)
E. Place Top Frame (B) onto Upright Frame (F) and Guide Post (G) and secure
using:
Two 9 (M8x20 hex head bolt)
Two 8 (M8x15 hex head bolt)
Two 21 (M8 washer)
Two 20 (M8 arc washer)
Two 6 (M10x80 hex head bolt)
Four 19 (M10 washer)
Two 13 (M10 nylon nut)
LEFT SIDE ASSEMBLY
diagram. Make sure the pre-drilled holes are positioned closest to Top Frame
(B).
18