Screen Control Menu; Pip / Pop Menu - Sony LMD-2735MD Instructions For Use Manual

Submenu Setting
ACC Sets the ACC (Auto Color Control)
circuit to "On" or "Off. "
CTI Sets the CTI (Chroma Transient
Improvement) circuit to "On" or "Off. "
When a low color resolution signal is
input, a crisp image can be displayed.
NTSC Setup Selects the NTSC setup level from
among "0%, " "7.5%. "

Screen Control menu

The Screen Control menu is used to set the image display
setting for each input.
Submenu Setting
HD Scan Size Sets the scan size for the HD signal
display.
Select from among "Off, " "Mode2, "
"Mode3. "
SD Scan Size Sets the scan size for the SD signal
display.
Select from among "Off, " "Mode1. "
Flip Pattern Sets the flip pattern of the display.
Select from among "Off, " "Rotation, "
"Mirror. "
SD Aspect Sets the aspect ratio of the SD signal
display.
Select from among "4:3, " "16:9. "
APA Select "On" to adjust the picture
automatically to maximum clarity when
an analog PC signal is displayed.
If the APA operation does not finish
correctly depending on the input signal,
adjust from among "Dot Phase" and
"Dot Pitch. "
Shift H Adjusts the horizontal position of the
picture. A higher setting moves the
picture to the right, and a lower setting
moves the picture to the left when an
analog PC signal is displayed.
Submenu Setting
Shift V Adjusts the vertical position of the
picture. A higher setting moves the
picture up, and a lower setting moves
the picture down when an analog PC
signal is displayed.
Dot Phase Adjusts the dot phase. Adjust the
picture further for a finer picture after
APA is adjusted when an analog PC
signal is displayed.
Dot Pitch Adjusts the horizontal size of the
picture with the left side of the picture
fixed. The higher the setting, the wider
the picture. The lower the setting, the
narrower the picture when an analog
PC signal is displayed.

PIP / POP menu

The PIP / POP menu is used to set the display mode for
the multi-image display and for each input.
Submenu Setting
Clipping Size Sets the HD clipping size for each port
when using multi-image display.
Select from among "Normal, " "4:3, "
"5:4. "
Sub Screen Position
PIP Sets the sub screen position for the
multi-image display (PIP).
Set the position of the sub screen with
the "Lower Left, " "Upper Left, " "Upper
Right, " and "Lower Right" icons.
POP Sets the sub screen position for the
multi-image display (POP).
Set the position of the sub screen with
the "Right" and "Left" icons.
Pattern Skip Sets the pattern that is skipped when
changing the displaying pattern by
pressing the PIP/POP button on the
front panel while displaying multi-
image display. Set to "Not Skip" or
"Skip" for the PIP1, PIP2, POP1, or
POP2 pattern.
21
Adjustment Using the Menus