Table of Contents
Advertisement
Submenu
Setting
Custom Button
Assigns the function to the CUSTOM 1,
CUSTOM 2 or CUSTOM 3 button on
the front panel, and can set the
following functions to on or off.
No Setting
Scan Size
Flip
POP Sub Screen Position
APA
Gamma
Mono
Phase
Chroma
Brightness
Contrast
Auto Input Select
On: Inputting signals to the input
connector automatically changes
connectors.
Off: The Auto Input Select function
does not operate. For details, see
page 22.
Preset menu
The Preset menu is used to set the User1 to 20 preset
setting.
Submenu
Setting
Load User Setting
Loads the settings that are stored User1
to 20.
Save User Setting
Stores the current settings to User1 to
20.
User Name
Registers the user names to User1 to 20.
Load Default
Loads the default settings.
Troubleshooting
This section may help you isolate the cause of a problem
and as a result, eliminate the need to contact technical
support.
The display is colored in green or purple When
HD15 is selected, perform the RGB/YPbPr selection
correctly.
The unit cannot be operated The key protection
function is enabled. Set the Control Lock setting to Off
in the Control Lock menu.
The black bars appear at the upper and lower
positions of the display When the signal aspect
ratio is different from that of the panel, the black bars
appear. This is not a failure of the unit.
Video images are not displayed on the screen. If
the PC signal is input to HD15, select RGB in RGB/
YPbPr.
The DVI-D signal image is not displayed. When
inputting the signal protected with HDCP in the DVI-
D
connector and the HDCP Setting is set to
"Disable, " the image is not displayed on the screen.
Set the HDCP Setting to "Enable. "
While the logo is displayed, the operation buttons
do not operate when pushed. While the logo is
displayed, the operation buttons do not operate. After
the logo disappears, the operation buttons can be
operated. The logo display time can be set in the menu.
For details, see page 23.
25
Troubleshooting
Hide quick links:
Advertisement
Table of Contents
