Connecting The Power Cord - Sony LMD-2735MD Instructions For Use Manual

Input DVI Rev.1.0 applicable digital signal.
connector
Active through output connector of the DVI digital
signal.
Outputs the signal which inputs to the
The signal protected by HDCP
1) HDCP (High-bandwidth Digital Content Protection) is a
copyright protection technology using encryption
technology of digital video signals.
Note
A signal is output from the connector only when the
monitor is turned on. When the monitor is turned off,
the signal is not output from the connector.

VIDEO input connector (BNC type)
The input connector for composite signals.

S-VIDEO input connector (4-pin mini-DIN)
The input connector for Y/C signals.
Do not come into contact with the terminals of the rear
panel connectors and patients at the same time.
Doing so may result in a generation of voltage that can be
harmful to patients if the unit is malfunctioning.
Always disconnect the power cord before connecting
and disconnecting connectors.
Using this unit for medical purposes
This equipment's connectors are not isolated.
Do not connect any device other than one which
conforms to IEC 60601-1.
When an information technology device or AV device
that uses an alternating current is connected, current
leakage may result in an electric shock to the patient or
operator.
If use of such a device is unavoidable, isolate its power
supply by connecting an isolation transformer, or by
connecting an isolator between the connecting cables.
After implementing these measures, confirm that the
reduced risk now conforms to IEC 60601-1.
connector.
1)
is not output.
Connecting the Power
Cord
To connect the power cord
1
Press the side of the
unit to the standby state.
2
Slide the shutter of the AC connector of the unit to
the right, then insert the AC power cord into the AC
input connector as illustrated.
To use the AC adaptor (sold separately)
Switch the unit to the standby state by pressing the
side of the switch, slide the shutter of the power
connector on the unit to the left, then insert the DC
connector into the DC input connector until it locks.
Next, insert the AC power cord into the separately sold
AC adaptor.
Shutter
DC input connector
DC connector
switch and switch the
AC input connector
Shutter
AC power cord
AC plug holder
15

Connecting the Power Cord