Martin Wizard User Manual page 20

6 - c h an n el D M X o p er at i on
The 6-channel and 8-channel mode functions are described in detail in "DMX
protocol" on page 31.
Channel 1 controls lamp on, lamp off, the dimmer and the strobe rate. It also
allows you to execute a random "stand-alone" program using automatic or music
trigger, and to reset the fixture to its home position.
Channel 2 controls the rotation of the parabolic reflector. This channel has no
effect if the stand-alone program is selected on channel 1.
Channel 3 controls the color wheel and is used to select colors, split colors, the
twinkle effect and color rotation. When the stand-alone program is running this
channel still has active control of the color wheel, unless the DMX value is set to
greater than 250 (>98%).
Channel 4 controls the gobo wheel. This channel functions even if the stand-
alone program is selected. When the stand-alone program is running this channel
still has active control of the gobo wheel, unless the DMX value is set to greater
than 250 (>98%).
Channel 5 controls the mirror drum's swivel position. This has no affect if the
stand-alone program is running.
Channel 6 controls mirror drum rotation direction and speed. This has no effect if
the stand-alone program is running.
8 - c h an n el D M X o p er at i on
Channel 7 controls the mirror drum swivel speed, allowing you to vary the speed
with controllers without cross-fade times. If your controller has cross-faders and
you use them, turn the speed function off by setting channel 7 to 0 percent. This
channel has no effect if the stand-alone program is running.
Channel 8 provides speed control of the color and gobo wheels, allowing you to
program slow or fast transitions from one effect position to another. This channel
has no effect if the stand-alone program is running.
Setting the DMX mode
1 Disconnect the fixture from power. Set DIP-switch pin 10 to OFF.
2 To select:
• 1-channel DMX mode, set DIP-switch pin 11 to ON.
• 6-channel DMX mode, set DIP-switch pin 11 to OFF.
• 8-channel DMX mode, set DIP-switch pin 11 to OFF, and then follow the procedure
in "Setting 6- or 8-channel DMX mode" on page 27.
20 Wizard user manual