Blockage Related - Pelpro PPC90 User Manual

Troubleshooting

Blockage Related

Black soot on outside of house
• Confirm exhaust path is clean and clear (Zone 3)
- Adjust air/fuel ratio using trim adjustment dial
(See page 17 for trim adjustment instructions)
• Ensure termination cap has at least 18" clearance
to reduce the effects of soot blow-back on home
exterior (ie. siding)—if not able, refer to page 10
for alternate installation options
Rumbling/whistling noise during operation
• Confirm exhaust path is clean and clear (Zone 3)
- Adjust air/fuel ratio using trim adjustment dial (See page 17 for trim adjustment
instructions)
Stove will not light
• Confirm firepot holes are clean and clear (Zone 1)
- Ignitor is getting hot (glows orange)
• Inspect stove body (Zone 2)
- Confirm fuel is in hopper, close lid securely
- Remove right side panel to access and confirm vacuum switch is clear and
connected at both ends
- Confirm all exhaust blower connections secure
- Confirm the feed assembly and motor are clean and clear of debris
• Confirm exhaust path is clean and clear (Zone 3)
pelprostoves.com PelPro Cast Pellet Stove • 7093-600 • 07/13/16
Zone Zone
1 1
Zone Zone
3 3
Zone Zone
2 2
23