Page 1
PelPro Cast Iron Pellet Stove WARNING! Please read this entire manual before installation and use of this pellet fuel-burning room heater, and save for future refer- ence. Failure to follow these instructions could result in property damage, bodily injury or even death. Contact local building or fire officials about restrictions and installation inspection requirements in your area.
Page 2
Indicates additional information to help you better understand your stove and optimize its performance. Notice: Fire Risk Pelpro disclaims any responsibility, and the warranty and agency listing will be voided, by the below actions. DO NOT: • Install or operate damaged appliance •...
Troubleshooting............22 • Power related • Blockage related Support..............27 • Contact information • Ordering Parts Listings and Certifications........28 • Mobile home approval • Glass specification • Efficiencies • Stove dimensions • Warranty pelprostoves.com PelPro Cast Pellet Stove • 7093-600 • 07/13/16...
Getting Started Pallet Removal Pallet Removal Visit pelprostoves.com There are bolts holding your PelPro stove in place or scan this code. on the pallet. To remove your stove from the pallet: Using a 7/16” wrench, Using a 3/8” wrench, remove all four bolts...
(<1%) less than 1.5” in length and avoid the dusty bits and pieces of pellets in the bottom of the bag. pelprostoves.com PelPro Cast Pellet Stove • 7093-600 • 07/13/16...
• Wood • Sheet rock (drywall) • Carpet WARNING! Asphyxiation Risk. DO NOT INSTALL IN A SLEEPING ROOM. Consumes oxygen in the room. For Canada, the installation must conform to CAN/CSA-B365 PelPro Cast Pellet Stove • 7093-600 • 07/13/16 pelprostoves.com...
Page 7
Listed double wall flue connector to Class A Listed metal chimneys, or masonry chimneys meeting International Conference of Building Officials (ICBO) standards for solid fuel appliances. Installation Video Visit pelprostoves.com or scan this code: pelprostoves.com PelPro Cast Pellet Stove • 7093-600 • 07/13/16...
• The safest and preferred venting method is to extend the vent vertically through the roof or above the roof PelPro Cast Pellet Stove • 7093-600 • 07/13/16 pelprostoves.com...
Straight back against wall Inches Walls to stove Horizontal Installations Straight back against wall Inches Back wall to stove Side wall to stove Clearance to top of stove Clearance to front of stove 1219 pelprostoves.com PelPro Cast Pellet Stove • 7093-600 • 07/13/16...
• Your stove appliance will not draft properly that can build up a concentration of fumes such as a stairwell, • Smoke may seep in your house covered breezeway, etc. • Excessive sooting PelPro Cast Pellet Stove • 7093-600 • 07/13/16 pelprostoves.com...
Page 11
Minimum Vertical Vent for Two Elbows Minimum Vertical Vent for Three Elbows Minimum Vertical Vent for One Elbow Length of Horizontal Sections (FT) Length of Horizontal Sections (FT) Horizontal Run (FT) Horizontal Run, (ft) pelprostoves.com PelPro Cast Pellet Stove • 7093-600 • 07/13/16...
Page 12
Wall, floor or ceiling cavity _____ Pipe joints are secure and properly sealed • Enclosed space such as an attic, garage or crawl space. _____ Outside air kit installed properly _____ Confirm termination clearances PelPro Cast Pellet Stove • 7093-600 • 07/13/16 pelprostoves.com...
Your stove has a manufacture-set minimum low burn rate that must not be altered. It is against federal regulations to alter this setting or otherwise operate your stove in a manner inconsistent with opertion instructions in this manual. pelprostoves.com PelPro Cast Pellet Stove • 7093-600 • 07/13/16...
• CAREFULLY SUPERVISE children in same room as fireplace • Alert children and adults to hazards of high temperatures • High temperatures may ignite clothing or other flammable materials • Keep clothing, furniture, draperies and other flammable materials away PelPro Cast Pellet Stove • 7093-600 • 07/13/16 pelprostoves.com...
Page 15
WARNING! Shock hazard. • Plug directly into properly grounded 3 prong receptacle • Do NOT route cord under or in front of appliance • Recommend the use of a surge protector pelprostoves.com PelPro Cast Pellet Stove • 7093-600 • 07/13/16...
(approximately 15 minutes) and restart. Thermostat Your PelPro stove comes with a built-in thermostat system that provides easy temperature adjustments. An external thermostat is available as an option (sold separately). To use an external thermostat: Install according to the manufacture’s instructions and connect to the back of your stove.
Now you can unplug appliance before servicing • Smoke spillage into room can occur if appliance is not cool before unplugging pelprostoves.com PelPro Cast Pellet Stove • 7093-600 • 07/13/16...
Apply ceramic glass cleaner • Use non-abrasive cloth to remove residue Door Inspection • The gasketing between the glass and firebox should be inspected periodically to make sure there is a good seal. pelprostoves.com PelPro Cast Pellet Stove • 7093-600 • 07/13/16...
Zone Zone • Vacuum any debris from the fan blades and blower housing Hopper • Empty hopper of any pellets • Vacuum any remaining pellets/debris from the hopper PelPro Cast Pellet Stove • 7093-600 • 07/13/16 pelprostoves.com...
Page 21
Your chimney should be inspected once every few months during the heating season to determine if a creosote or soot buildup has occurred. If creosote or soot has accumulated, it should be removed to reduce the risk of a chimney fire. pelprostoves.com PelPro Cast Pellet Stove • 7093-600 • 07/13/16...
• Check all connections and power plugs are secure Zone Zone Zone Zone Zone Zone • Visually inspect wires, blowers and power cord to find cause of possible short circuit PelPro Cast Pellet Stove • 7093-600 • 07/13/16 pelprostoves.com...
- Confirm all exhaust blower connections secure - Confirm the feed assembly and motor are clean and clear of debris • Confirm exhaust path is clean and clear (Zone 3) pelprostoves.com PelPro Cast Pellet Stove • 7093-600 • 07/13/16...
Page 24
(Zone 3) • Examine stove body (Zone 2) - Align igniter so it is properly placed and centered - Review fuel quality (see Pellet Fuel information on page 5) PelPro Cast Pellet Stove • 7093-600 • 07/13/16 pelprostoves.com...
Page 25
Convection blower has exceeded Dirty Clean the allowable Failed Replace temperature. Installation Review the installation and move if necessary. Installation configuration is tight allowing for limited air circulation around the unit. pelprostoves.com PelPro Cast Pellet Stove • 7093-600 • 07/13/16...
Page 26
All replacement parts are covered for remainder of 90 Days original warranty period or 90 days, whichever is longer Additional terms and limitations apply. See page 30 for complete warranty information. PelPro Cast Pellet Stove • 7093-600 • 07/13/16 pelprostoves.com...
• Order replacement parts • Installation videos • Troubleshooting videos • Use and care videos • Manuals and more To contact a Consumer Care Specialist, email us at Info_PelPro@hearthnhome.com or call 877-427-3316. pelprostoves.com PelPro Cast Pellet Stove • 7093-600 • 07/13/16...
• The appliance must be secured to the mobile home structure by bolting it to the floor through holes provided at bottom of your cast legs on your stove. PelPro Cast Pellet Stove • 7093-600 • 07/13/16 pelprostoves.com...
Listings and Certifications Glass Specifications This appliance is equipped with 5mm ceramic glass. Replace glass only with 5mm ceramic glass. Please contact PelPro for replacement glass. Electrical Rating (On High) PPC90/TSC90 Series: 115 VAC, 60 Hz, Start 2.6 Amps, Run 0.9 Amps BTU &...
Page 30
This limited warranty gives you specific legal rights and you may have other rights, which vary from state to state. Warranty is void if the PelPro appliance has not been installed, operated, cleaned and maintained in strict accordance with HHT’s instructions.
Page 31
Serial Number:__________________________________________________________ (located on back of your stove) Store purchased from: ____________________________________________________ Store Location: _________________________________________________________ Maintenance Log: ______________________________________________________________________ ______________________________________________________________________ ______________________________________________________________________ ______________________________________________________________________ ______________________________________________________________________ ______________________________________________________________________ ______________________________________________________________________ ______________________________________________________________________ ______________________________________________________________________ ______________________________________________________________________ ______________________________________________________________________ ______________________________________________________________________ ______________________________________________________________________ ______________________________________________________________________ pelprostoves.com PelPro Cast Pellet Stove • 7093-600 • 07/13/16...
Page 32
Hearth & Home Technologies | 7571 215th Street West | Lakeville, Minnesota 55044 ® PelPro Cast Pellet Stove • 7093-600 • 07/13/16...