Blockage Related; Temperature Rating: -50°F To 350°F 75292 - Pelpro PP60 Owner's Manual

Troubleshooting

Blockage Related

Black soot on outside of house
• Confirm exhaust path is clean and clear (Zone 1
and 3)
- Adjust air/fuel ratio using trim adjustment dial
(See page 23 for trim adjustment instructions)
• Ensure termination cap has at least 18" clearance
to reduce the effects of soot blow-back on home
exterior (ie. siding)—if not able, refer to page 10
for alternate installation options
Rumbling/whistling noise during operation
• Confirm exhaust path is clean and clear (Zone 1 and 3)
- Adjust air/fuel ratio using trim adjustment dial (See page 18 for trim adjustment
instructions)
Appliance will not light
• Confirm firebox is clean and clear (Zone 1)
- Igniter is getting hot (glows orange)
• Inspect appliance body (Zone 2)
- Confirm fuel is in hopper, close lid securely
- Remove right side panel to access and confirm vacuum switch is clear and
connected at both ends
- Confirm all exhaust blower connections secure
- Confirm the feed assembly and motor are clean and clear of debris
• Confirm exhaust path is clean and clear (Zone 3)
pelprostoves.com
PelPro Cast Pellet Stove • 7083-171N • 9/8/17
DRAWN BY:
2. Deje enfriar la unidad antes de realizar cualquier trabajo de mantenimiento. MCW
THIS PRINT IS CHECKED AND CONTROLLED BY THE ENGINEERING B ADDED WWW.PELPROSTOVES.COM
CONFIDENTIAL PROPERTY OF HEARTH & HOME TECHNOLOGIES INC. DEPARTMENTS OF HEARTH & HOME TECHNOLOGIES INC.
A RELEASED
The appliance will automatically maintain the desired comfort level and shut down when level has REV
3
L'appareil passera automatiquement maintenir le niveau de confort désiré et arrêter lorsque le
El aparato mantendrá automáticamente el nivel de confort deseado y se cerrará cuando el nivel se ha
** The appliance will run continuously until switched to OFF or COMFORT LEVEL mode.
L'appareil fonctionne de façon continue jusqu'à ce que passe en mode OFF ou NIVEAU DE CONFORT.
El aparato funciona continuamente hasta que cambia al modo OFF o NIVEL DE CONFORT. Remove / Supprimer / Quitar
NOTE:
1. MATERIAL: NON-ANODIZED ALUMINUM 0.020 THICK
2. BACKGROUND: SILVER
3. COPY: BLACK
4. ADHESIVE: 3M #468 PERMANENT ACRYLIC
5. TEMPERATURE RATING: -50°F TO 350°F
75292 06/05/14 MCW
D GROUPED LANGUAGES, REMOVED PHONE NUMBER
74013 01/07/14 WPK
C BACKGROUND AND COPY NOTE UPDATD
73351 9/3/2013 WPK
Zone
1
Zone
2
SCALE: MATERIAL:
1:1 1. Gire el dial de control en la posición OFF. SEE NOTE
SHEET: PART NUMBER: 75290 REV: 06/05/14 MCW
2. Deje enfriar la unidad antes de realizar cualquier trabajo de mantenimiento. 1 OF 1 7083-167 B
72901 06/19/13 MCW
REVISIONS ECO # DATE BY
2
*
The appliance will automatically maintain the desired comfort level and shut down when level has
been achieved.
L'appareil passera automatiquement maintenir le niveau de confort désiré et arrêter lorsque le
niveau a été atteint.
El aparato mantendrá automáticamente el nivel de confort deseado y se cerrará cuando el nivel se ha 1
logrado.
** The appliance will run continuously until switched to OFF or COMFORT LEVEL mode.
L'appareil fonctionne de façon continue jusqu'à ce que passe en mode OFF ou NIVEAU DE CONFORT.
El aparato funciona continuamente hasta que cambia al modo OFF o NIVEL DE CONFORT.
UNLESS OTHERWISE SPECIFIED DIMS ARE INCHES[MM] & : TOLERANCES ARE: (2) PLACE DEC : ± 0.03 (3) PLAC
OUTSIDE MATERIAL. NORMAL DIM & INSIDE MATERIAL.
Zone
3
25