Rear Suspension - Arctic Cat XF 7000 Operator's Manual

Hide thumbs Also See for XF 7000:
Table of Contents

Advertisement

2. When the lubricant has completely
drained from the case and the chain
case is cleaned of old oil; then install
the chain case cover. Tighten the cap
screws to 105 in.-lb.
CAUTION
Before installing the chain case
screws, be sure to clean the holes
using compressed air completely of
debris or damage to the chain case
may occur.
3. On the 6000, pour recommended
chain case lube into the fill hole until
the lubricant is at least halfway up in
the sight glass; then install the plug.
4. On the 7000, remove the three
screws securing the shift actuator to
the chain case, disconnect the actua-
tor wiring harness, and remove the
actuator w/extension. Pour recom-
mended chain lube through the shift
actuator opening until the lubricant
is at least halfway up in the sight
glass; then install the shift actuator
w/extension and connect the actua-
tor wiring harness.
26
NOTE: Make sure the reverse sen-
sor wire is routed up so the wires do
not become pinched between the
actuator and the case.
CAUTION
When installing the shift actuator,
rotate the actuator back and forth to
properly align it with the extension
gear. Failure to do so could cause
component damage.
5. Install and secure the exhaust reso-
nator.
6. On the 7000, start the engine and
verify proper reverse and forward
operation by shifting in and out of
reverse three times.
CAUTION
The correct lubricant to use in the
chain case is Arctic Cat Synthetic
Chain Lube. Any substitute may
XM092
cause serious damage to the drive
system.

Rear Suspension

This procedure should be done every 40
operating hours.
NOTE: Arctic Cat recommends that
Arctic Cat All-Temp Grease (p/n 4639-
365) be used for this procedure.
NOTE: Illustrated are the general
locations of grease fittings. Actual loca-
tions will vary from model to model.
1. Using Handlebar Stand (p/n 5639-
152) or Steering Post Stand (p/n
5639-946) or a suitable substitute,
lay the snowmobile on its left side.
3. Lubricate all grease fittings with all-
temperature grease.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

M 6000Zr 6000Zr 7000

Table of Contents