Table of Contents
Advertisement
3. If the lubricant level is above the add mark, the
lubricant level is satisfactory. If the lubricant level
is at or below the add mark, proceed to step 4.
4. If oil is low, add transmission lube through the oil
level stick filler hole. When the oil level is correct,
install the oil level stick.
NOTE: If excessive oil deposits are noticed, the
chain case must be serviced. Also, when the oil
level is at the add mark, approximately 60 ml (2 fl
oz) of transmission lube must be added to the
chain case.
CAUTION
The correct lubricant to use in the chain case is Arctic
Cat Transmission Lube (p/n 4639-364). Any substitute
may cause premature chain failure or serious damage
to the chain drive system.
FRONT SUSPENSION
It is very important that the bellcrank is greased on a
monthly basis using a good low-temperature grease.
The bellcrank should also be greased after trailering
the snowmobile on an open trailer. Pump grease into
the grease fittings and wipe excess grease from the
bellcrank.
34
REAR SUSPENSION
1. Shut engine off and wait for all moving parts to
stop.
2. With the gas tank nearly empty (less than 1/4 full),
lay the snowmobile on its side. A piece of card-
board should be used to protect the finish on the
hood and belly pan.
NOTE: Prior to tipping the snowmobile on its
side, apply the brake and set the brake lever lock.
3. Remove ice and snow buildup from the skid frame
to expose the grease fittings.
728-948A
4. Lubricate the grease fittings with an all-tempera-
ture grease.
0744-878
0741-175
0744-072
Advertisement
Table of Contents
