Lubrication; Chain Casechain Case; Rear Suspension - Arctic Cat M 9000 King Cat Operator's Manual

Chain Case

NOTE: The snowmobile must be
on a level surface for this procedure.
Check the lubricant level in the chain
case by using the sight glass.

NOTE: The correct level is when
the lubricant is at least halfway up in
the sight glass.

NOTE: Adding lubricant can be
done by the snowmobile owner if
qualified to do so. If the owner does
not feel qualified, take the snowmo-
bile to an authorized Arctic Cat
Snowmobile dealer for this service.
This service is at the discretion and
expense of the snowmobile owner

NOTE: Make sure the snowmobile
is fully shifted into forward.
1. If the lube level is low, remove the
three screws securing the heat shield
and the shift actuator to the chain
case, disconnect the actuator wiring
harness, and remove the actuator
extension, shift detent, and spring.
2. Add appropriate amount of Syn-
thetic Chain Lube through the shift
actuator opening until the lube is
halfway up the sight glass.

Lubrication

3. Install the actuator extension and
4. Remove the actuator extension; then
5. Install spring into the bottom of

NOTE: Rotate the extension clock-
wise approximately 20° making sure
not to pull out the extension when
0746-115
rotating. This is only to aid in the
installation of the actuator.
6. Install the actuator with heat shield
7. Connect the harness to the gear posi-
.
8. Start the engine and verify proper

NOTE: If excessive build-up of
moisture
detected in the chain case, it may be
necessary to replace the lube.

Rear Suspension

0750-340
This procedure should be done every 40
operating hours.
gently rotate counter clockwise to
make sure the shift fork is in the for-
ward position.
re-install the actuator extension
making sure the notch in the exten-
sion is directed downward.
detent block and install into the
chain case cover. The notch in the
extension should be lined up with
the notch in the block.
and secure using the existing three
torx screws. Tighten to 36 in.-lb.
tion sensor; then secure the connec-
tors to the main harness using a
cable tie.
reverse and forward operation by
shifting in and out of reverse three
times.
or discolored
XM467
oil is
17