Battery (Electric Start) - Arctic Cat XF 7000 Operator's Manual

Hide thumbs Also See for XF 7000:
Table of Contents

Advertisement

NOTE: If the cable/exhaust valve
does not move freely, the exhaust valve
assembly will need to be removed for
further inspection. Take the snowmo-
bile to an authorized Arctic Cat Snow-
mobile dealer for this service.
NOTE: When measuring the cables,
they are to be routed as close to their
installed position as possible.
5. While holding the cable housing,
lightly pull on one cable end to
remove any slack; then measure the
amount of exposed cable from the
cable housing to the end of the cable
(cable drum).
APV CABLE LENGTH
6000
1.377 in. ± 0.039 in.
NOTE: The two cable measure-
ments must be equal in length or
less than 0.5 mm (0.020 in.) differ-
ence in length from each other.
NOTE: Repeat steps 4 and 5 for each
cable; then compare the measure-
ments to the APV Cable Length chart.
NOTE: The measurements must be
within the specifications from the
chart. If the measurements are
within specifications, no adjustment
is necessary (proceed to step 8). If
they are not within specifications,
proceed to step 6.
6. Loosen the jam nut on the cable to
be adjusted; then using the adjusting
nuts, lengthen or shorten the housing
as needed.
7. Once the proper length has been
attained, hold the adjusting nut in place
and tighten the jam nut securely.
34
8. Place the cable housings into posi-
tion in the servomotor. Secure the
cable housings with the cable holder.
CAUTION
Assure the cables are rotated and
secured properly to avoid contacting
exhaust components.

Battery (Electric Start)

These sealed batteries after being in ser-
vice
require
recharging in order to deliver peak per-
formance and maximum service life. The
following procedures are recommended
for cleaning and maintaining sealed bat-
teries. Always read and follow instruc-
tions provided with battery chargers and
battery products.
NOTE: Battery maintenance may
be done by the snowmobile owner if
qualified to do so. If the owner does
not feel qualified, take the snowmo-
bile to an authorized Arctic Cat
Snowmobile dealer for this service.
This service is at the discretion and
expense of the snowmobile owner.
To remove and charge the battery, use the
following procedure:
0735-516
! WARNING
Improper handling or connecting of a
battery may result in severe injury
including acid burns, electrical burns,
or blindness as a result of an explo-
sion.
Always
watches. Any time service is per-
formed on a battery, the following
must be observed: keep sparks, open
flame, cigarettes, or any other flame
away. Always wear safety glasses.
Protect skin and clothing when han-
dling a battery. When servicing a bat-
tery in an enclosed space, keep the
area well-ventilated.
! WARNING
Battery posts, terminals, and related
accessories contain lead and lead
compounds, chemicals known to the
state of California to cause cancer
and reproductive harm. Wash hands
after handling.
regular
cleaning
and
remove
rings
and

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

M 6000Zr 6000Zr 7000

Table of Contents