Table of Contents
Advertisement
Back to Contents Page
Coin-Cell Battery
Dell™ Inspiron™ 1318 Service Manual
Removing the Coin-Cell Battery
Replacing the Coin-Cell Battery
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions shipped with your system.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as a connector on the back of the computer).
NOTICE:
To help prevent damage to the system board, you must remove the battery from the battery bay before you begin working inside the
computer.
Removing the Coin-Cell Battery
1. Follow the procedures in
Before You
2. Remove the module cover (see
3. The battery is glued to the computer, use a plastic scribe to pry the coin-cell battery from the slot.
4. Disconnect the coin-cell battery cable from the system board connector.
1
coin-cell battery cable connector
Replacing the Coin-Cell Battery
1. Connect the coin-cell battery cable to the system board connector.
2. Peel off the adhesive on the coin-cell battery and adhere it to the system board.
3. Replace the module cover (see
4. Slide the battery into the battery bay, until it clicks into place.
Back to Contents Page
Begin.
Module
Cover).
2
coin-cell battery
Module
Cover).
Advertisement
Table of Contents
