Maintenance And Service; Maintenance Schedule - Husqvarna P520 D Operator's Manual

Maintenance schedule

WARNING! No service procedures must be conducted on the engine or cutting unit unless:
!
The engine is switched off.
The parking brake is applied.
The ignition key is removed.
The cutting unit is disengaged.
The following is a list of the maintenance which should be conducted on the machine. For those points not described in this manual,
visit an authorised service workshop.
Maintenance
Check the safety system
Check for fuel and oil leakage.
Check the engine's oil level
Check coolant level and antifreeze.
Checking the transmission oil level
Check and clean the engine's cooling air intake, clean
the radiator.
Cleaning
Start engine and blades, listen for noise
Check nuts and screws
Clean underside of cutting unit
Lubricate throttle cable
Grease the blade shafts
Check air filter
Check the tyre pressures.
Lubricate according to lubrication schedule, see under
heading "LUBRICATION"
Clean thoroughly around engine
Clean thoroughly around transmission
Clean the air filter and empty the particle collector
Checking the blades
Replace the fuel filter.

MAINTENANCE AND SERVICE

Daily maintenance
Before starting
After work is
completed
X
O
X
X
X
X
X
O
O
X
Maintenance interval in hours
10 40 100 200 400
X
X
X
X
X
X
X
X
X X
X
X
X
X
X
English
800
– 25