Assembling And Adjustments; Safety When Assembling And Settings; Cutting Unit; Fitting The Cutting Head - Husqvarna P520 D Operator's Manual

ASSEMBLING AND ADJUSTMENTS

Safety when assembling and
settings
WARNING! The engine emits carbon
!
monoxide, which is a colourless, poisonous
gas. Do not use the machine in enclosed
spaces.
• Never leave the machine unsupervised with the engine
running. Always stop the blades, apply the parking brake,
stop the engine and remove the keys before leaving the
machine.
• Never allow children or other persons not trained in the
use of the machine to use or service it. Local laws may
regulate the age of the user.
• Electrical shocks can cause injuries. Do not touch cables
when the engine is running. Do not test the ignition
system with your fingers.
WARNING! The engine and the exhaust
!
system become very hot during operation.
Risk of burn injuries if touched.
• The machine is tested and approved only with the
equipment originally provided or recommended by the
manufacturer.

Cutting unit

The Cutting Unit Components
The components mentioned are:
3 2
4
8
1 Cotter pin
2 Link joint
3 Cutting unit bracket
4 Clipping height adjusters
5 Universal drive shaft with quick connectors
6 Attachment point for service position
7 Service strut
8 Belt cover
9 Gear
12 –
English
9 5
6
4
7

Fitting the cutting head

1 Place the machine on a flat surface and apply the parking
brake.
2 Start the engine and lower the lift arms to floating mode.
WARNING! If the help function is engaged,
!
the lift arms will move with great force if
someone releases the lifting lever. Observe
caution to avoid trapping your hand.
Risk of crush injuries.
3 Turn off the motor.
4 Fit the universal drive shaft to the cutting unit. Slide the
ring sideways to release the quick coupling and the
universal drive shaft can be pushed onto the shaft pin.
5 Make sure the rubber casing is folded over the front
universal joint.
1
6 Remove the bolts and pins from the link joint on the lift
arms.
7 Slide in the cutting unit so that the link joint aligns with the
opening in the unit.