Husqvarna P520 D Operator's Manual page 26

Maintenance
Change engine oil and filter
Check the synchronisation between the front and rear
wheels.
Change hydraulic oil and hydraulic filter
Check belt tension and condition (alternator belt, PTO
belt, cutting unit belt)
Check the battery condition, clean as necessary.
Clean transmission air intake
Check oil level in the bevel gear, top up if necessary.
Check the wheel nuts.
Check the parking brake
2)
Replace the air filter .
Change belts (PTO belt and cutting unit belt).
Change the oil in the bevel gear.
Change pump and alternator belt
Change coolant (50% glycol).
Service at an authorised service representative.
1)
First change after 25 hours. When operating with a heavy load or at high ambient temperatures, replace every 50 hours.
Maintenance and replacement are required more often in dusty conditions.
authorised service workshop.
X = Described in this operator's manual
O = Not described in this operator's manual
IMPORTANT! When the machine is in operation the hoses are under high pressure. Do not try to connect or disconnect the hoses
when the hydraulic system is operational. This can result in serious personal injuries.
26 –
English
MAINTENANCE AND SERVICE
1)
3, 4)
.
Daily maintenance
After work is
Before starting
completed
X
3)
First change after 25 hours.
Maintenance interval in hours
10 40 100 200 400
1)
X
O
3, 4)
O
X
X
X
X
O
X
2)
X
X
X
X
O
4)
Conducted by
800
X
2)