Removing The Cutting Unit - Husqvarna P520 D Operator's Manual

ASSEMBLING AND ADJUSTMENTS

Removing the cutting unit

WARNING! Never leave the universal drive
!
shaft of the machine with one end loose. If
the engine is started, damage can occur.
1 Place the machine on a flat surface and apply the parking
brake.
2 Raise the cutting unit halfway.
3 Turn off the motor.
4 Remove the lifting eyes from the cutting unit.
5 Start the engine and lower the cutting unit to the lowest
position (floating mode). The cutting unit now hangs free
at the back.
6 Turn off the motor.
7 Remove the service hatch.
8 Remove the universal drive shaft completely.
14 –
English
9 Slide the ring sideways to release the quick coupling and
the universal drive shaft can be pulled from the shaft pin.
10 Remove the pins from the shafts and remove the shafts
from the link joints.
WARNING! If the help function is connected,
!
the lift arms move with great force when the
pins are loosened. Observe caution to avoid
trapping your hand.