Innova 3040c Owner's Manual page 9

See Figure 2 for the locations of items 1 through 11, below.
1. I/M MONITOR STATUS field – Identifies the I/M Monitor status area.
2. Monitor icons - Indicates which Monitors are supported by the
vehicle under test, and whether or not the associated Monitor has
run its diagnostic testing (Monitor status). When a Monitor icon is
solid green, it indicates that the associated Monitor has completed
its diagnostic testing. When a Monitor icon is flashing red, it
indicates that the vehicle supports the associated Monitor, but the
Monitor has not yet run its diagnostic testing.
3. Vehicle icon - Indicates whether or not the Scan Tool is being
properly powered through the vehicle's Data Link Connector (DLC).
A visible icon indicates that the Scan Tool is being powered through
the vehicle's DLC connector.
4. Link icon - Indicates whether or not the Scan Tool is
communicating (linked) with the vehicle's on-board computer. When
visible, the Scan Tool is communicating with the computer. If the
Link icon is not visible, the Scan Tool is not communicating with the
computer.
5. Computer icon - When this icon is visible it indicates that the
Scan Tool is linked to a personal computer. Optional "PC Link"
software is available that makes it possible to upload retrieved data
to a personal computer.
6. DTC Display Area - Displays the Diagnostic Trouble Code (DTC)
number and definition. Each fault is assigned a code number that is
specific to that fault.
7. Test Data Display Area – Displays DTC definitions, Freeze Frame
data, and other pertinent rest information messages.
8. MIL icon - Indicates the status of the Malfunction Indicator Lamp
(MIL). The MIL icon is visible only when a DTC has commanded the
MIL on the vehicle's dashboard to light.
9. FREEZE FRAME icon - Indicates that "Freeze Frame" data has been
stored in the vehicle's computer for the currently displayed DTC.
10. Code Type – Indicates whether the code is "generic" or
"manufacturer-specific" and shows the type of code; Stored, Pending
or Permanent.
11. Code Number Sequence – Shows the number of the currently
displayed code and the total number of codes retrieved from the
vehicle's computer. The Diagnostic Tool assigns a sequence
number to each DTC that is present in the computer's memory,
starting with "1." Code number "1" is always the highest priority code,
and the one for which "Freeze Frame" data has been stored.
If "01" is a "Pending" code, there may or may not be "Freeze
Frame" data stored in memory.
3040c
About the Scan Tool
DISPLAY FUNCTIONS
7