Innova 3040c Owner's Manual page 37

11. To read the display:
Refer to DISPLAY FUNCTIONS on page 6 for a description of
display elements.
A visible
through the vehicle's DLC connector.
A visible
(communicating with) the vehicle's computer.
The I/M Monitor Status icons indicate the type and number of
Monitors the vehicle supports, and provides indications of the
current status of the vehicle's Monitors. A solid green Monitor
icon indicates the associated Monitor has run and completed its
testing. A blinking red Monitor icon indicates the associated
Monitor has not run and completed its testing.
The display shows the number of
the code currently being displayed,
the total number of codes retrieved,
and whether or not the displayed
code commanded the MIL on. If the
code being displayed is a PENDING
code, the PENDING icon is shown.
If the code being displayed is a
PERMANENT code, the PERMA-
NENT icon is shown.
The Diagnostic Trouble Code (DTC) and related code definition
are shown in the lower section of the display.
In the case of long code definitions, or when viewing Freeze
Frame Data, a small arrow is shown in the upper/lower right-hand
corner of the Scan Tool display area to indicate the presence of
additional information. Use the
as necessary, to view the additional information.
If a definition for the currently displayed code is not available,
an advisory message shows on the Scan Tool's display.
12. Read and interpret the Diagnostic Trouble Codes using the LCD
display and the green, yellow and red LEDs.
The green, yellow and red LEDs are used (with the LCD
display) as visual aids to make it easier to determine
engine system conditions.
Green LED - Indicates that all
engine systems are "OK" and
running normally. All monitors on
the vehicle are active and are
performing their diagnostic testing,
and no trouble codes are present. A
zero will show on the Scan Tool's
display, and all Monitor icons will be
solid.
3040c
icon indicates that the Scan Tool is being powered
icon indicates that the Scan Tool is linked to
Using the Scan Tool
CODE RETRIEVAL PROCEDURE
UP and DOWN buttons,
35