Innova 3040c Owner's Manual page 43

To exit the enhanced mode, press the M button to return to the
Main Menu. Use the UP
necessary, to highlight Global OBD, then press the ENTER
button to return to the Global OBD2 mode.
Ford/Mazda Enhanced DTCs
Mazda Enhanced DTCs are available for Mazda-branded
Ford vehicles only.
When OEM Enhanced is chosen from the
Main Menu (and Ford is selected when
prompted), the
displays. You may view DTCs for either the
"Continuous Memory Test", "KOEO (Key
On Engine Off) Test" or "KOER (Key On
Engine Running) Test."
1. Use the UP
as necessary, to highlight the desired
option, then press the ENTER
If KOER is selected, an advisory
message shows on the Scan Tool's
display.
- Start and warm the engine to
normal
then press the ENTER
Proceed to step 3.
2. If KOEO or Continuous Memory is
selected, an "instructional" message
shows on the Scan Tool's display.
Turn the ignition OFF, then back
ON. Press the ENTER
Proceed to step 3.
3. A "One moment please" message
displays while the test is in progress.
If the Scan Tool fails to link to the
vehicle's computer, a "Communication
Error" message shows on the Scan
Tool's display.
- Ensure your vehicle is OBD2
compliant.
COVERED on page 4 for vehicle
compliance verification information.
- Verify the connection at the DLC, and verify the ignition is ON.
- Turn the ignition OFF, wait 5 seconds, then back ON to reset
the computer.
- Press the ENTER
3040c
Ford Enhanced
and DOWN buttons,
operating temperature,
See VEHICLES
button to continue.
Using the Scan Tool
VIEWING ENHANCED DTCs
and DOWN
menu
button.
button.
button.
buttons, as
41