Viewing Vehicle Information - Innova 3040c Owner's Manual

The
Menu displays.
3. Use the UP
as necessary, to highlight Alternator
Monitor, then press the ENTER
button.
A "One moment please" message
displays,
retrieves the requested information.
4. When the battery check is complete, a
results screen displays the current
Battery Voltage.
5. Press the ENTER
the alternator check.
An instructional screen displays.
6. Press the accelerator pedal to raise
engine speed to 1500~1700 RPM, and
maintain the engine speed for 10 seconds.
When engine speed is within the
required range, the alternator test
begins. A progress screen shows
the Engine RPM and Count down
(time remaining until the test is
complete).
7. When the alternator check is complete,
a results screen displays the current
Alternator
whether or not the voltage is within
acceptable limits. The System Status
LEDs provide a PASS/FAIL indication,
as follows:
Green = PASS
Yellow = Caution/LOW
Red = FAIL
If the alternator voltage is less than 9 V, the red, yellow and
green SYSTEM STATUS LEDs will flash on and off.
8. Press the M button to return to the Main Menu.

VIEWING VEHICLE INFORMATION

The Scan Tool offers three options for retrieving reference information
for the vehicle under test; Vehicle ID, Available Modules and IPT (In-
use Performance Tracking).
3040c
Battery/Alternator
and DOWN
while the Scan
button to perform
Voltage, and
Additional Functions
VIEWING VEHICLE INFORMATION
Monitor
buttons,
Tool
indicates
67