Innova 3040c Owner's Manual page 46

Using the Scan Tool
VIEWING ENHANCED DTCs
- Ensure your vehicle is OBD2 compliant. See VEHICLES
COVERED on page 4 for vehicle compliance verification infor-
mation.
- Verify the connection at the DLC, and verify the ignition is ON.
- Turn the ignition OFF, wait 5 seconds, then back ON to reset
the computer.
- Press the ENTER
If the Scan Tool cannot link to the
vehicle's
attempts, the message "Contact
Technical Support" displays.
- Press the M button to return to the
Main Menu.
- Turn the ignition off, and dis-
connect the Scan Tool.
- Contact Technical Support for assistance.
2. To read the display:
Refer to DISPLAY FUNCTIONS on page 6 for a description of
LCD display elements.
A visible
through the vehicle's DLC connector.
A visible
Scan Tool is linked to (communicating
with) the vehicle's computer.
The display shows the number of
the code currently being displayed,
the total number of codes retrieved.
The Diagnostic Trouble Code (DTC)
and related code definition are
shown in the lower section of the
LCD display.
44
button to continue.
computer after
icon indicates that the Scan Tool is being powered
icon indicates that the
If the definition for the cur-
rently displayed code is not
available, an advisory mes-
sage shows on the Scan
Tool's LCD display.
I/M MONITOR STATUS
icons are not displayed
when viewing enhanced
DTCs.
In the case of long code definitions, or when viewing Freeze
Frame data, a small arrow is shown in the upper/lower
right-hand corner of the code display area to indicate the
presence of additional information. Use the UP
DOWN buttons, as necessary, to view the additional
information.
three
and
3040c