The Scan Tool will display a code only
if codes are present in the vehicle's
computer memory. If no codes are
present, a "No Enhanced DTC's are
presently stored in the vehicle's
computer" is displayed. Press the M
button to return to the Main Menu.
3. If more than one code was retrieved press the DTC button, as
necessary, to display additional codes one at a time.
4. When the last retrieved DTC has been displayed and the DTC
button is pressed, the Scan Tool returns to the "Priority" code.
To view additional enhanced DTCs, repeat steps 1 through 4,
above.
To exit the enhanced mode, press the M button to return to the
Main Menu. Use the UP
necessary, to highlight Global OBD, then press the ENTER
button to return to the Global OBD2 mode.
Honda/Acura Enhanced DTCs
When OEM Enhanced is chosen from the
Main Menu, (and Honda is selected when
prompted), the Scan Tool retrieves OEM
enhanced
DTCs
computer.
1. A "One moment please" message
displays while the Scan Tool retrieves
the selected DTCs.
If the Scan Tool fails to link to the
vehicle's computer, a "Communica-
tion Error" message shows on the
Scan Tool's display.
- Ensure your vehicle is OBD2
compliant.
COVERED on page 4 for vehicle
compliance verification information.
- Verify the connection at the DLC, and verify the ignition is ON.
- Turn the ignition OFF, wait 5 seconds, then back ON to reset
the computer.
- Press the ENTER
continue.
If the Scan Tool cannot link to the
vehicle's
attempts, the message "Contact
Technical Support" displays.
- Press the M button to return to the
Main Menu.
3040c
from
the
vehicle's
See
VEHICLES
button to
computer
after
Using the Scan Tool
VIEWING ENHANCED DTCs
and DOWN
three
buttons, as
45