Installation - HIKVISION TURBO HD DS-2CE56D(F)7T-IT1 User Manual

2 Installation

Before you start:
 Please make sure that the device in the package is in
good condition and all the assembly parts are
included.
 Make sure that all the related equipment is power-off
during the installation.
 Check the specification of the products for the
installation environment.
 Check whether the power supply is matched with
your required output to avoid damage.
 Please make sure the wall is strong enough to
withstand three times the weight of the camera and
the mounting.
 If the wall is the cement wall, you need to insert
expansion screws before you install the camera. If the
wall is the wooden wall, you can use self-tapping
screw to secure the camera.
 If the product does not function properly, please
contact your dealer or the nearest service center. Do
not disassemble the camera for repair or
maintenance by yourself.
2.1 Installation of Type I Camera
2.1.1 Ceiling Mounting
Steps:
1. Disassemble the turret camera by rotating the
camera to align the notch to one of the marks, as
shown in Figure 2-1.
2. Pry the mounting base to remove the mounting
base with the camera body with a flat object, e.g., a
coin.
3. Attach the drill template (supplied) to the place
where you want to fix the camera, and then drill the
screw holes and the cable hole in the ceiling
according to the drill template.
Cable Hole
4. Fix the mounting base to the ceiling with the screws.
Figure 2-1 Disassemble the Camera
Figure 2-2 Drill Template
Mark
Notch
Screw Hole