Table of Contents
Advertisement
Figure 2-3 Fix the Mounting Base and Camera
5. Route the cables through the cable hole and
connect the video cables and power cord.
6. Secure the camera to the mounting base.
Figure 2-4 Fix the Camera to the Ceiling
7. Adjust the camera according to Figure 2-5 to get an
optimum angle.
1). Hold the camera body and rotate the enclosure
to adjust the pan angle [0° to 360°].
2). Move the camera body up and down to adjust
the tilt angle [0° to 75°].
3). Rotate the camera body to adjust the Loosen
No.3 adjusting azimuth angle [0° to 360°].
Pan Position Range
[0°-360°]
Tilt Position Range
[0°-75°]
2.2 Installation of Type II Camera
2.2.1 Ceiling Mounting without Gang Box
Steps:
1. Disassemble the turret camera by rotating the
camera to align the notch to the clip plate, as shown
in Figure 2-6.
2. Pry the mounting base to remove the mounting
base with the camera body.
3. Attach the drill template (supplied) to the place
where you want to fix the camera, and then drill the
Figure 2-5 3-axis Adjustment
Figure 2-6 Disassemble the Camera
Rotation Position Range
[0°-360°]
Clip Plate
Notch
Advertisement
Table of Contents
