Troubleshooting - Beko WTE7604XLW0 Owner's Manual

8

Troubleshooting

Problem
Water in the washer.
Washer does not fill with
water or wash after the
program was selected and
the "Start/Pause/Cancel"
button was pressed.
Washer does not drain
water / Washer drains
water slowly.
The water being taken in is
directly discharged.
No water can be seen in
the drum during washing.
Washer stopped shortly
after the program cycle
started.
Owner's Guide & Installation Instructions
Cause
There may be some water in your
appliance when you receive it. This
is from the quality control process
and is normal.
Faucets may be turned off.
Water inlet hose may be folded.
Water inlet strainers might be
clogged.
Is there power at the outlet?
Washer might be unplugged.
Drain hose may be folded.
Washer may be in handwash, wools
or soak cycle.
Drain pump filter or drain itself may
be clogged.
Door may not be closed properly.
Drain hose may be folded.
Drain pump filter or drain itself may
be clogged.
Improper position of the drain hose.
This is not a problem. The water
level is not visible from the outside
of the washer.
Washer can stop temporarily due to
low voltage.
Explanation / Suggestion
It is not harmful to your washer. You
should run a "sanitary" cycle without
any clothes and laundry additives
before the first use of your washer.
Open the water faucets fully.
Check the water inlet hose and
straighten if necessary.
Clean the water inlet strainers.
Call an electrician and have the power
outlet / circuit breaker / fuse checked.
Plug the power cord to a live electrical
outlet.
Check the drain hose and straighten if
necessary.
Wait for a short time and tumbling will
start.
Clean the drain pump filter (See "User
maintenance instructions" ). If the
house drain pipes are clogged, call a
plumber for assistance.
Close the loading door.
Check the drain hose and straighten if
necessary.
Clean the drain pump filter (See "User
maintenance instructions" ). If the
house drain pipes are clogged, call a
plumber for assistance.
Connect the drain hose as described
in the user manual (See "Installation
Instructions, Drainage").
It will resume operating when the
voltage is back to the normal level.
43 / English