Descaling The Washer - Beko WTE7604XLW0 Owner's Manual

User maintenance instructions
Do the following as shown in the figure below:
• Pull out the emergency drain hose from its housing.
• Place a large container at the end of the hose. Drain the water off into the container by pulling out
the plug at the end of the hose. If the amount of water to be drained off is greater than the volume
of the container, replace the plug, pour the water out, then resume the draining process.
• After draining process is completed, replace the plug into the end of the hose and fit the hose back
into its place.
• When there is no water left, turn the pump filter until it is completely loose and remove it.
• Clean any residues inside the filter as well as fibers, if any, around the impeller region.
• Never force the filter while replacing it into its housing. Fit the filter fully into its housing; otherwise,
water may leak from the filter cap.
4- Close the filter cap.
Close the two-piece filter cap of your product by pushing the tab on it.
Close the one-piece filter cap of your product by fitting the tabs on the bottom into their positions and
pushing the upper part of it.

Descaling the washer

Hard water can cause scale build-up inside the drum and other parts of your washer in time. Scaling
may lead to some serious problems such as clogging in hoses, heater or pump failure eventually.
To prevent scaling, wash drum should be cleaned frequently. Do not use abrasive materials such as
metal wool while cleaning the drum.
Take the manufacturer's instructions into account if you are using a descaling agent. Descaling agents
may contain materials that are hazardous for washer components. Use descaling agents compatible
for use in clothes washers.
When using a powder descaling agent, add 1 cup to the main wash compartment of the dispenser and
run a regular hot cycle (with extra rinse) without any clothes and detergents.
42 / English Front-Loading Automatic Washer