Beko WTE7604XLW0 Owner's Manual page 44

Troubleshooting
There is water coming
from the bottom of the
washer.
Washer fills with water
when a process is
cancelled.
Time delay function does
not work.
The door will not open.
The door will not lock/
door expression is on LCD
44 / English
Inlet hose connections may be
leaking.
End of the drain hose may be loosely
inserted into the waste pipe or sink.
House drain may be clogged.
Filter cap of the drain pump may not
be properly fitted.
Hose connections inside the washer
may be leaking.
There may be hot water inside
washer.
Door may not be closed properly.
Water level might be above the
lower level of the door.
Washer might be heating up the
water or it may be at the spinning
cycle.
Due to electrical safety mechanism,
the door can only be opened a few
minutes after the program has
stopped.
If the door can not be opened after
minimum ten minutes the program
has stopped , on/off buton should be
placed to off position.
Door is not properly closed/Door
hinge is not aligned with lock
switch.
Be sure the strainers and rubber seals
of the water inlet hoses are solid and
securely fitted.
Tightly attach the drain hose to the
waste pipe or sink (See "Installation
Instructions, Drainage").
If the house drain pipes are clogged, call
a plumber for assistance.
Make sure that the pump filter cap is
tightly closed.
Internal hose connections (e.g.
dispenser hoses, drain system) should
be checked by a service technician.
For safety reasons, water should be
cycled in and out a couple times.
Close the loading door.
Run "Drain" , "Spin" or "Drain&Spin"
program.
Wait until the process is over.
Wait until the process is over.
In this situation, call the qualified
service technician.
Push the loading door firmly shut until
you hear it lock into space
Front-Loading Automatic Washer