Installation Checklist; Transportation - Beko WTE7604XLW0 Owner's Manual

Installation Instructions
• Be sure to secure the drain hose tightly to the pipe (stand pipe, drain pipe/edge of the sink) with a
strap etc.
• The hose should be placed between 16 and 39 in. (40 and 100 cm) from the floor level
• If you have floor drain system, you can place the drain hose in the hole located on the floor.

Installation Checklist

• Water inlet hoses and accessory bags must be removed from the wash drum.
• Transportation/shipping bolts must be removed.
• Washer must be properly leveled by using the adjustable feet.
• Water inlet hoses are connected to the water faucets, secured and checked for any leaks by
turning on both faucets.
• Drain installation is done properly and drain hose is checked and secured to prevent any flooding.
• Washer is connected the junction box which is plugged to a properly grounded live mains outlet.
• Be sure that power outlet, water faucets and drain outlet must be always accessible to the user.

Transportation

Before you transport the washer, you should carry out the following:
1. Turn off both water faucets.
2. Before you disconnect the water inlet hoses, decrease the pressure inside hoses by turning on the
washer choosing any wash program. As soon as the Start/Pause/Cancel led starts blinking, turn off
the appliance. You may securely disconnect inlet hoses without any water gush.
3. Disconnect the drain hose and hang it on the back plate by inserting into the holder plastic
brackets.
4. Unplug the power cord and hang it on the back plate by inserting into the holder plastic brackets.
5. Remove bolt hole covers and reinstall shipping bolts to their places. You can apply the procedure in
chapter "Removing shipping bolts" in reverse to accomplish this.
6. Be sure that rubber bushes are properly located in holes and bolts are screwed back tightly for
secure transportation of the appliance.
16 / English Front-Loading Automatic Washer