Notes For The Installer; Transit Fittings - Miele PW 6241 Operating Instructions Manual

This machine must be installed by an
authorised technician only. In the UK any
gas heated machines must be installed
by a Gas Safe registered engineer.
,
This machine is not designed for
washing items which have been treated
with dangerous or flammable substances.
Transport packaging must be carefully
removed using suitable tools.
The machine must be level and secure after
installation (see installation diagram
supplied with the machine).
To avoid the risk of frost damage do not
install this machine in a room where there is
a risk of frost occuring.
Do not install the machine on carpeted
flooring as the carpet pile can hinder the
free flow of air into the ventilation gaps at the
bottom of the machine.

Transit fittings

Brackets "A" (2 on each side) are secured
with hex screws which have to be removed
using a suitable tool.
Transit fittings "B", (2 at the front adn 2 at the
back) are secured with 3 hex screws each.
These have to be removed on site before the
machine is commissioned for use.
M.-Nr. 06 572 495

Notes for the installer

To do so the access panel and the rear
panel of the machine have to be removed.
Unscrew the hex screws from the bottom
edge of the front access panel and then take
the access panel off.
Unscrew the hex screws from the back
panel and then take the back panel off.
The front plinth facing is screwed to the
back panel. The rear plinth facing is located
under the machine lid and has to be fitted
after the machine has been successfully set
up. Screws are supplied in the accessories
pack for this.
Store the transit fittings in a safe place for
future use. They will need to be refitted
should the machine every need to be
moved to another location.
Use a pallet lifter to move the machine
around the room.
The machine must not be moved without
all the outer panels in place.
37