Error Messages - Miele PW 6241 Operating Instructions Manual

Service interval
If after switching the machine on the
following message appears in the display
the machine will need to be serviced by the
Miele Service Department.
Service interval 1
§
Call the Service Department
The display will go out after 5 minutes.

Error messages

,
Repairs to electrical, gas or steam
operated machines may only be carried
out by a suitably qualified person in
accordance with national and local safety
regulations. In the U.K. repairs to gas
heated machines must only be carried out
by a Gas Safe registered technician.
A message will appear in the display if there
is a problem either before starting a
programme or once it has started:
The display remains dark.
There is no power to the machine.
^ Check the mains switch and the on-site
fuses.
Power cut
y
Programme stop
Press the start button.
^ Once power has been restored press the
START button.
This error message can also indicate that
the winding on the motor has overheated.
^ Allow the motor to cool down.
M.-Nr. 06 572 495
Water inlet fault
M
Call the Service Department
if restart does not work.
i
^ Check the stopcock and then press the
START button.
A
Door lock fault
a
Call the Service Department
if restart does not work.
i
^ Push firmly on the door handle until you
hear the lock engaging. Confirm by
pressing START.
Heating system fault
§
Programme stopped. Press start.
Programme will continue without heat.
i
^ To continue the programme with heating
press the START button. If a disinfection
programme was running the programme
will be cancelled if this message appears.
Call the Service Department.
Drive motor fault
m
Programme stopped. Press the start button.
Motor overheating.
i
^ Allow the motor to cool down.
Imbalance fault
§
Call the Service Department
f
if restart does not work.
i
The imbalance is too great and the
imbalance switch has been activated.
^ Switch the machine off and on again. Then
press the START button.
Problem solving guide
f
f
f
f
A
31