Table of Contents
Advertisement
The washer-extractor must be installed
and commissioned by an approved Cus-
tomer Service technician or authorised
Service Dealer.
Installation
A concrete floor is the most suitable installa-
tion surface. Please note:
^ The machine must be level and securely
positioned.
^ Do not install the machine on a 'soft' base
such as floorboards as this could result in
more vibration during the spin cycles.
^ If the machine is installed on a raised
plinth it should be secured using the butt
straps supplied with the machine.
If there is not already a concrete plinth
on-site, the Miele Spare Parts department of-
fer a steel plinth. The steel plinth must be se-
cured to the floor, (see the enclosed installa-
tion plan).
To avoid the possibility of frost damage on
no account install the machine in a room
which is exposed to frost.
Transit fittings
When the machine has been installed in its
final position, only then remove the red tran-
sit fittings marked "A", "B". and "C".
M.-Nr. 06 006 810
Notes for the installer
Front transit fitting
The front panel must be taken off, (2 internal
torx T20 screws at the bottom) in order to re-
move the front transit fitting (3 SW-13
screws).
Rear transit fitting
"B" (1 piece)
The rear panel must be taken off, (just
loosen 15 internal torx T20 screws at the bot-
tom) in order to remove the rear transit fitting
(3 SW13 screws each).
The machine must not be moved without the
transit fittings in place.
"A" (1 piece)
"C" (1 piece)
29
Hide quick links:
Advertisement
Table of Contents
