Notes For The Installer; Transit Fittings - Miele WS 5071 Operating Instructions Manual

Washer-extractor
Table of Contents

Advertisement

Notes for the installer

Installation
A concrete floor is the most suitable installa-
tion surface. Please note:
The machine must be level and securely
positioned.
Do not install the machine on a 'soft' base
such as floorboards as this could result in
more vibration during the spin cycles.
If the machine is installed on a raised
plinth it should be secured using the butt
straps supplied with the machine.
If there is not already a concrete plinth on-
site, the Miele Spare Parts department offer a
steel plinth. The steel plinth must be secured
to the floor, (see the enclosed installation
plan).
To avoid the possibility of frost damage on no
account install the machine in a room which is
exposed to frost.

Transit fittings

When the machine has been installed in its
final position, only then remove the red transit
fittings marked "A", "B". and "C".
Front transit fitting
"A" (1piece)
The front panel must be taken off,
(2 internal torx T20 screws at the bottom) in
M.-Nr. 05616270
order to remove the front transit fitting (3 SW-
13 screws) .
Rear transit fitting
"B" (1piece)
The rear panel must be taken off, (just loosen
15 internal torx T20 screws at the bottom) in
order to remove the rear transit fitting (3
SW13 screws each) .
The machine must not be moved without
the transit fittings in place.
The transit fittings should be stored in a safe
place for future use. They must be re-fitted if
the machine is moved again.
Do not install the machine on carpeted floor-
ing if the carpet pile blocks the ventilation gap
at the base of the machine.
The machine must not be moved without
all the outer panels in place.
32
"C" (1piece)

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents