Power; Mounting Orientation And Location - Martin Imager Series Operator's Manual

Po wer
Power is supplied from an Imager Base via the Imager J-Box. They are
connected using the following two cables (not supplied):
• Lamp power out cable - 5 x 1 mm2 (AWG 18)
• Low voltage output cable - 4 x 0.75 mm2 (AWG 18)
This product must be mounted or supported independently of an outlet box.
During installation of this equipment consult a qualified electrician to ensure
correct branch circuit conductor.
M ou nti ng o rie nt a tion a nd locati on
Do not locate the Imager luminaire in an unventilated space. Install the
fixture in a location where it is:
• at least 0.5 meters (20 inches) away from the surface to be illuminated,
• at least 1 meter (40 inches) away from any combustible materials, and
• away from accidental public contact.
Installing the J-Box
All Imager luminaires must be mounted using an Imager J-Box. Securely
fasten the J-Box to a ceiling surface using 4 units of 6 mm (1/4 in.) mounting
hardware appropriate to the mounting surface and appropriate to the
combined weight of the J-Box and the Imager.
12 Installation