Brake Light Switches; Adjusting The Clutch Lever Free Play - Yamaha BANSHEE 350 YFZ350A Owner's Manual

1/8 turn and tighten its locknut to the specified
torque. NOTICE: When tightening the lock-
nut, hold the adjusting bolt with a wrench
so that it does not turn together with the
locknut.
[ECB00521]
Tightening torque:
Locknut (rear brake caliper):
16 Nm (1.6 m·kgf, 12 ft·lbf)
EWB02090
WARNING
Operating with improperly serviced or adjust-
ed brakes could cause the brakes to malfunc-
tion, resulting
performance. This could increase the chance
of a collision or accident. After adjusting the
parking brake free play, block the rear of the
ATV off the ground and spin the rear wheels.
Check to make sure there is no brake drag. If
brake drag is noticed, perform the adjustment
again.
EBU24742

Brake light switches

The brake light, which is activated by the brake
pedal and brake lever, should come on just before
in reduced braking
braking takes effect.
The brake light switch for the brake pedal can be
adjusted as follows, but the front brake light switch
should be adjusted by a Yamaha dealer.
Turn the adjusting nut while holding the brake light
switch in place. To make the brake light come on
earlier, turn the adjusting nut in direction (a). To
make the brake light come on later, turn the adjust-
ing nut in direction (b).
1
(a)
1. Brake light switch
2. Rear brake light switch adjusting nut
EBU24812

Adjusting the clutch lever free play

The clutch lever free play must be checked and, if
8-41
1
2
3
4
5
2
6
(b)
7
8
9
10
11