Yamaha BANSHEE 350 YFZ350A Owner's Manual page 90

To change the transmission oil
1. Place the ATV on a level surface.
1
2. Start the engine, warm it up for several min-
utes, and then turn it off.
2
3. Place an oil pan under the transmission case
to collect the used oil.
3
4. Remove the oil filler cap, the transmission oil
drain bolt and its gasket to drain the oil from
4
the transmission case.
5
2
6
7
1
8
9
1
10
1. Transmission oil drain bolt
11
2. Gasket
5. Install the transmission oil drain bolt and its
new gasket, and then tighten the bolt to the
specified torque.
Tightening torque:
Transmission oil drain bolt:
20 Nm (2.0 m·kgf, 14 ft·lbf)
6. Refill with the specified amount of the recom-
mended transmission oil, and then install and
tighten the oil filler cap.
Recommended transmission oil:
See page 10-1.
Oil quantity:
1.5 L (1.59 US qt, 1.32 Imp.qt)
TIP
Be sure to wipe off spilled oil on any parts after the
engine and exhaust system have cooled down.
ECB00430
NOTICE
G
In order to prevent clutch slippage (since the
transmission oil also lubricates the clutch),
do not mix any chemical additives. Do not
use oils with a diesel specification of "CD" or
oils of a higher quality than specified. In ad-
dition, do not use oils labeled "ENERGY
CONSERVING II" or higher.
G
Make sure that no foreign material enters the
8-12