Yamaha BANSHEE 350 YFZ350A Owner's Manual page 108

1
1
2
3
4
5
6
1. Float
2. Needle valve
7
3. Main jet
8
14. Change the main jet and the jet needle clip po-
sition.
9
TIP
10
G Optional main jets can be obtained at a Yamaha
dealer.
11
G
After the jet needle clip position is changed, the
throttle cables may need to be adjusted.
Assembling and installing the carburetors
Assemble and install both carburetors by the fol-
3
2
8-30
lowing steps.
1. Install the needle valve and float.
2. Install the float chamber by installing the
screws.
3. Install the carburetor and tighten the joint
screws.
4. Assemble the throttle valve.
5. Install the mixing chamber cap, and then tight-
en it securely to the specified torque.
Tightening torque:
Mixing chamber cap:
4 Nm (0.40 m·kgf, 2.9 ft·lbf)
6. Install the mixing chamber cap securing plate
by installing the screw. NOTICE: Be sure to
match one of the projections on the carbu-
retor cap with one of the slots on the se-
curing plate. If the securing plate does not
match a projection, tighten the carburetor
cap until they align. Do not loosen the car-
buretor cap.
[ECB00502]