Yamaha BANSHEE 350 YFZ350A Owner's Manual page 52

transmission allows you to control the amount of
power you have available at a given speed or for
1
starting, accelerating, climbing hills, etc.
To shift into neutral, release the throttle lever, ap-
2
ply the clutch, and then repeatedly depress the
shift pedal until it stops.
3
When it stops, it will be in first gear. Raise the pedal
slightly to reach the neutral position, and then re-
4
lease the clutch.
5
6
6
7
5
4
3
8
2
9
1
10
2
1. Shift pedal
11
2. Neutral position
EBU20592
To start out and accelerate
1. Release the throttle lever, apply the front or
1
rear brake, and then release the parking
brake.
ECB00200
NOTICE
Always close the throttle before shifting gears,
otherwise damage to the engine and drive train
may result.
2. Pull the clutch lever to disengage the clutch.
3. Shift into first gear, and then release the
brake.
4. Open the throttle gradually and at the same
time, release
WARNING! Opening the throttle abruptly
or releasing the clutch lever too quickly
could make the ATV wheelie, which would
increase the chance of an accident, includ-
ing an overturn.
5. Once the ATV has attained adequate speed,
release the throttle, and at the same time,
quickly pull in the clutch lever.
6. Shift the transmission into second gear.
(Make sure not to shift the transmission into
neutral.)
7. Open the throttle part way and gradually re-
lease the clutch lever.
8. Follow the same procedure when shifting to
6-3
the clutch lever slowly.
[EWB00731]